Subcooling (ΔTsc)

Subcooling is a way to describe how far a liquid refrigerant is below its saturation temperature at the same pressure. It’s commonly used to interpret condenser outlet and liquid line conditions in refrigeration, HVAC, and heat pump systems.

Definition (at the same pressure)

Subcooling is defined relative to the saturation temperature at the measured pressure:

If the liquid temperature is below the saturation temperature at that pressure, the liquid is “subcooled” by ΔTsc. If the liquid is at saturation, ΔTsc is near zero. (This page is educational — always follow OEM and local code requirements for field work.)

Why subcooling is useful (conceptually)

• Liquid margin: subcooling indicates how much “temperature headroom” the liquid has before it starts to flash (boil) as pressure drops.
• Expansion device stability: a stable liquid feed helps many systems avoid flash gas upstream of an expansion device.
• State interpretation: it provides a simple “distance from saturation” metric on the liquid side (similar to superheat on the vapor side).

How to calculate subcooling (safe workflow)

1. Measure the liquid line pressure at (or near) the location that matches your procedure.
2. Measure the liquid line temperature at the same location (good sensor contact and insulation matter).
3. Compute Tsat(P) for the same refrigerant using the measured pressure.
4. Compute ΔTsc = Tsat(P) − Tliquid.

Avoid generic “target subcooling” numbers from random sources. Targets and procedures depend on equipment design (TXV/EEV, receiver, subcooler, controls), operating conditions, and manufacturer guidance.

Blends: bubble vs dew (important)

For refrigerant blends, saturation can span a temperature range (temperature glide). A common convention is:

Not all charts/tools/procedures use the same convention. Always confirm the procedure you are following (and the refrigerant type).

Common pitfalls (why calculations look “wrong”)

• Gauge vs absolute pressure: many field gauges report gauge pressure. If you convert, you need the correct local atmospheric pressure. See Gauge vs absolute pressure (psig vs psia).
• Sensor location mismatch: pressure at one point and temperature at another can create an artificial ΔTsc due to pressure drop and heat gain/loss along the line.
• Bad temperature measurement: clamp sensors need good thermal contact and often insulation to avoid being biased by ambient air.
• Not actually liquid: if flashing occurs, the temperature can behave differently and simple “liquid line” assumptions break down.

Using FluidTool

You can use FluidTool to compute Tsat(P) for a refrigerant and build intuition for how quickly saturation temperature moves with pressure. For blends, compare endpoints using a two-phase input (P + Q at Q=0 and Q=1).

Related concepts

• Superheat & Subcooling: the paired “distance from saturation” concepts.
• Refrigerant PT chart: how Tsat(P) is used and misused in practice.
• Saturation pressure vs temperature: the underlying relationship.